KEF PSW2000/2010 Active Sub Woofers

UPDATE

Because of the number of issues I have seen with KEF PSU2000 sub-woofers, I am no longer accepting repair jobs on them. The mechanical construction makes them awkward to work on, and they seem to have just too many almost insoluble problems.

However, I leave this page up as it may be of interest or useful to some.

SUMMARY

These boxes, made by British manufacturer KEF, are floor standing cubes that are about 35 cm square. They contain a single bass speaker, some preamp electronics and a power amplifier.

In this article I describe some modifications which makes them run cooler. This should help their long term reliability. Two are described : one is a redesign of the low voltage power supply. The other is a simple mechanical change which allows air to flow in and out of the enclosure that houses the electronics. I also give some measurements I made of the internal air temperature, with and without the mods.

Read more

Dynacord “Eminent” Valve Amplifier Restoration And Conversion

Dynacord Eminent Valve Amp

The Dynacord “Eminent” is a nice old German made valve amp that I was asked to restore. It was originally designed as a small mono PA. It has two instrument and two mic inputs, simple bass and treble tone controls, and 4, 8 and 16 ohm output taps. The owner wanted to repurpose this lovely amp for recording guitar. This is an account of the work involved.

Read more

8 ohm load for testing power amplifiers

This is a very simple project that takes only a few hours to make. It is a pair of 8 ohm resistive loads which can be used to test a mono or stereo power amplifier.

Dummy 8 ohm load built on an old baking tray

If you are working on an audio amp, you often need to see how it will behave when it is delivering power to a load. Using real loudspeakers is not practical, especially if you want to test at high levels and with sine waves. The noise would be unbearable, also you might damage a speaker. So you need a load to use instead of a loudspeaker.

Read more